|
WAC 296-806-20052: Agency filings affecting this section: Make sure two-hand devices meet these requirements. http://apps.leg.wa.gov/WAC/default.aspx?cite=296-806-20052Model 6010 - Two-Hand Machine Control. Designed to meet European standards for two-hand control devices (EN 574) http://www.nolatron.com/6010.htmlWAC 296-806-45524: Agency filings affecting this section: Make sure two-hand trip devices used to safeguard the point of operation meet these requirements. http://apps.leg.wa.gov/WAC/default.aspx?cite=296-806-45524MODEL 6010 -Two-Hand Machine Control Designed to meet European standards for two-hand control devices (EN 574) Model 6010 requires a machine operator to have both hands on start ... http://www.nolatron.com/Literature/6010brch.pdfMake sure two-hand devices meet these requirements. IMPORTANT: All devices must meet the general requirements for devices found in Make sure ... http://www.lni.wa.gov/WISHA/Rules/machinesafety/HTML/296-806-200-3.htm ... reach into the point of operation with his hands; (c)(3)(vii) The two-hand control device ... from any control button shall cause the slide to stop. (b) Each two-hand control shall meet ... http://www.rockfordsystems.com/downloads/pdf/FAB/TwoHandControl.pdfMake sure two-hand devices meet these requirements: WAC 296-806-20052: Make sure devices used with barrier guards meet ... http://www.lni.wa.gov/WISHA/Rules/machinesafety/HTML/296-806-200.htm ... channels closed). The DUO-TOUCH Two-Hand Control system has been designed to meet: ? Type IIIA/B requirements of ISO 13851 (EN 574) Safety of Machinery - Two-Hand Control Devices ... http://info.bannersalesforce.com/xpedio/groups/public/documents/literature/47550.pdf ... two hand control device ... meet the construction requirements of paragraph (b)(7)(v) of this section. (c) The safety distance (Ds) between each two-hand control device and ... http://www.pinnaclesystems.com/ut_design_criteria.html ... only a supervisor or safety engineer is capable of relocating the controls. When applying two-hand trip to meet the requirements for a point-of-operat ion safeguarding device ... http://www.rockfordsystems.com/downloads/pdf/FAB/TwoHandTrip.pdfTwo-Hand Controls can be used as safeguarding devices in the single stoke mode of operation on ... Each two-hand control must meet the construction requirements ... http://www.osha.gov/SLTC/etools/machineguarding/presses/twohandcont.htmlRenco Controls meet or exceed all applicable OSHA Standards of this date ... A two-hand no-tie-down control is a device which requires an operator to have both hands ... http://www.rencocontrols.com/HR7800A Compact Light Beam/Curtain with RT6/RT7. Two-Hand Device. HT5400A Two-Hand Device with JSBR4 ... document may reflect only a portion of the overall control system, and may not meet ... http://www.jokabsafetyna.com/products/safetyrelay/connectionexamples.html ... two-hand control device ... two-hand control shall meet the construction requirements of section 4193 (e). (3) The safety distance (Ds) between the closest hand control device and ... http://www.dir.state.ca.us/title8/4208.htmlThe two-hand devices require the operator to press two palm buttons simultaneously; the buttons ... only one set of requirements instead of employers trying to decide whether to meet ... http://www.osha.gov/dea/lookback/psdi_final2004.html |